The Edelbrock #8562 bolt kit contain a complete set of the highest quality head bolts and hardened washers available. Cold-formed to ensure molecular integrity and heat treated prior to thread rolling and machining. Reduced diameter bolt heads eliminate the need for valve train removal to facilitate cylinder head re-torqueing. Hardened and parallel-ground washers are included. Rated at 170,000 p.s.i.
Specifications:
| Description_ABR |
HeadBlotKit |
| Description_ASM |
Ford:Clevor:302 (5.0L) |
| Description_DEF |
Engine Cylinder Head Bolt Set |
| Description_EXT |
Edelbrock #8562 is a Head Bolt Kit for S/B Ford 302 E-Boss with Edelbrock #61699 cylinder heads on a 8.2" deck (302) block. Includes 7/16" Hex Head Bolts & #9680 Washer/Bushings to use 7/16" bolt in the 1/2" cylinder head bolt holes. |
| Description_INV |
302 Ford E-Boss Head Bolt Kit |
| Description_MKT |
The Edelbrock #8562 bolt kit contain a complete set of the highest quality head bolts and hardened washers available. Cold-formed to ensure molecular integrity and heat treated prior to thread rolling and machining. Reduced diameter bolt heads eliminate the need for valve train removal to facilitate cylinder head re-torqueing. Hardened and parallel-ground washers are included. Rated at 170,000 p.s.i. |
| Description_LAB |
302 Ford E-Boss Head Bolt Kit |
| Description_TRA |
The Edelbrock #8562 is made specifically for Ford Clevor |
| Description_TRA |
Apply oil or suitable thread lubricant to head bolt threads and the underside of bolt heads and washers. |
| Description_TRA |
Using the torque sequence (See Figure 1), torque all 7/16" bolts to 65-70 ft./lbs and all 1/2" bolts to 100-110 ft./lbs in four steps (30, 40, 50, 60-75 |
| Description_TRA |
or 30, 60, 90, 100-110). |
| Description_TRA |
Installation is the same as for original equipment cylinder heads. Consult service manual for specific procedures, if necessary. |
| Description_TRA |
BOSS 302 CLONE ENGINES - Use Edelbrock Head Bolt Bushings with Integral Washers #9680 in place of washers supplied with your head bolt kit. Torque 7/16" bolts to 65-70 ft./lbs. in four steps (30, 40, 50, 65-70) following the factory tightening sequence. ALL ENGINES - A re-torque is recommended after initial start-up and cool-down (allow 2-3 hours for adequate cooling). |
| RGL |
WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov. |
| Thread Diameter |
0.4375 |
| Thread Type |
Coarse |
| Minimum Length |
4.50 |
| Washers Included |
Yes |
| Quantity |
Kit |
| Material |
Chromoly |
| Grade Type |
Performance |
| Length |
(20) 4.50 |
| Finish |
Black Oxide |
| Head Drive Type |
Hex |
| Length |
9.0000 |
| Width |
3.0000 |
| Height |
8.0000 |
| Weight |
4.0000 |
