Edelbrock part #8728 spacer kit includes a 7/16" thick spacer and two 3/64" thick gaskets for a total thickness of 1/2". The kit also has new base to upper fasteners to accommodate the spacer. There are several benefits to the kit. First it raises the upper manifold 1/2" for increase valve cover to upper plenum clearance. It also provides heat insulation between the lower and upper manifolds. As a third benefit the 1/2" extra runner length helps to produce more torque. Fits all Victor 5.0 PN 2945 based manifolds.
Specifications:
| Description_ABR |
2945MAN SPCR |
| Description_ASM |
Ford:Mustang V8:302 (5.0L) |
| Description_DEF |
Engine Intake Manifold Spacer |
| Description_EXT |
Edelbrock Wood Fiber Laminate 1/2" Base to Upper Spacer Plate kit for Victor 5.0 Manifolds PN 2945. Includes spacer plate, two gaskets, and longer bolts |
| Description_LAB |
Engine Intake Manifold Spacer #8728 For Edelbrock Manifold Part #2945, 3887 |
| Description_MKT |
Edelbrock part #8728 spacer kit includes a 7/16" thick spacer and two 3/64" thick gaskets for a total thickness of 1/2". The kit also has new base to upper fasteners to accommodate the spacer. There are several benefits to the kit. First it raises the upper manifold 1/2" for increase valve cover to upper plenum clearance. It also provides heat insulation between the lower and upper manifolds. As a third benefit the 1/2" extra runner length helps to produce more torque. Fits all Victor 5.0 PN 2945 based manifolds. |
| Description_INV |
1/2" Base to Upper Spacer for Victr 5.0 |
| Description_TRA |
We recommend the use of Edelbrock Gasgacinch (Part #9300) on the intake manifold mounting surfaces of the cylinder head and on the bottom side of the intake manifold gaskets (side without silicon beads). The Gasgacinch will secure the gaskets in place, ensuring a proper seal. |
| Description_TRA |
Do not overtighten the manifold to base fasteners. Use a short box or open end wrench only. |
| Description_TRA |
Do not disconnect fuel lines unless absolutely necessary. Special tools and procedures are required to re-install fuel lines. |
| Description_TRA |
You must check your hood clearance before installation. Due to the 1/2" additional height of the spacer, this spacer will not fit under the stock hood on some vehicles. |
| Material |
Wood Fiber Laminate |
| Recommended Use |
For Edelbrock Part # 2945, 3887 |
| Quantity |
Kit |
| RGL |
WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov. |
| Thickness |
.500 |
| Mounting Hardware Included |
Yes |
| Length |
1.0000 |
| Width |
9.0000 |
| Height |
12.0000 |
| Weight |
1.0000 |
